close
close

How To Reset Tire Pressure Sensor Ram 1500

How To Reset Tire Pressure Sensor Ram 1500. To reset the tpms on the 2014 dodge ram 1500 make sure the tire pressure is correct, then turn on the vehicle. This action should reset the sensor.

How To Reset Tire Pressure Sensor Ram 1500 Thebabcockagency from zab.splunkyard.com

Wait for the light to blink three times, then release the button. Start your car and let the engine run for 20 minutes to reset the sensor. The light will flash three times.

Start The Engine And Let It Run For 20 Minutes.

Let the vehicle sit off for a minimum of 20 minutes; You just performed a hard reset on. Insert the key into the ignition, then turn the key to the “on” position without starting the car.

Press And Hold Down The Tpms Reset Button;

Sensor relearn procedure without a scan tool: Inflate all tires to pressure listed on the placard. Tpms tire pressure monitor sensor for dodge ram 1500 2500 from www.ebay.ca in some cases you may need to hold the button down till the light flashes.

In Some Cases You May Need To Hold The Button Down Till The Light Flashes.

Ram/dodge has tpms data linking receivers in each wheel well area that links data from the individual tire pressure sensor to the vehicle bcm (body control module). The vehicle will learn each sensor id and turn the tpms light off. The sensor needs to be reset to this activity.

After The Battery Reset, You Could Try Moving The Wheel/Tire To A Different Corner And See If The Problem Follows.

Preferably set the cruise control to assure this speed. The ram 1500 uses a direct tpms system, which means tpms sensors are installed in the wheel. Enter a highway and drive.

Drive For 10Mins @ 50Mph Or Higher.

Release, start the engine, and it’ll reset itself as you drive. Press the tpms reset button and hold it until the tire pressure light blinks three times, then release it. How do you reset the ram 1500‘s tire pressure light when it’s going off for no reason?

Leave a Reply

Your email address will not be published.